It will be located at the top of the panel.
Furnace high limit switch troubleshooting.
It s also known as a fan limit switch or simply a limit switch.
This article describes in detail the testing and diagnosis of problems with warm air heating furnace combination controls also commonly called the fan limit switch on warm air heating systems.
A limit switch also acts as a safety device for your furnace.
The limit switch is a safety switch that monitors t.
The switch makes sure the furnace is operating safely and at its desired settings.
For example if the blower motor stopped running then no air would move through the unit.
If the temperature inside of the plenum gets too hot it shuts off the gas supply to your burners to prevent your furnace and heat exchanger from overheating.
As a working example we examine the honeywell combination fan and limit control type l4064b.
So to put it simply the limit switch tells the furnace fan when to turn on and when to shut off and it tells the furnace to shut down if it is overheating.
Over time your furnace s limit switch can develop problems.
Remove the cover by lifting it upwards or pulling it off to reveal the body of the switch and two metal arms.
In this episode of repair and replace vance shows how to replace the high limit switch in a gas furnace.
When the high limit switch trips the flame heating element will be shut off and the blower will continue to run to clear the heat.
Depending on your furnace model the switch will be surrounded by a silver or white cover.
If the high limit switch was bad the furnace should not fire.
As a safety the high limit.
High limit switch a high limit control switch will turn off the gas to a furnace if the temperature becomes too high.
The blower will continue to run until either the system is reset or the limit switch closes.
What happens if your furnace limit switch stops working properly.
The flames would raise the temperature inside the unit and have no place to go getting hotter and hotter.
Some furnaces provide extra safety features by wiring two or three high limit switches in a series that check the temperature in the furnace at different points.
If the furnace failure code indicates an open limit or open high temperature switch or open rollout switch it is probable that the furnace has overheated.
